TECHNICAL DATA SHEET

SLV-P90

product description

Sanitred’s SLV P90 is a slow setting, low viscosity and odor, 90% solids polyaspartic polyurea which can be used where VOC limits are a concern.

STANDARD COLORS: CLEAR

OTHER COLORS AVAILABLE: N/A

REVISION DATE: May 28, 2021

CURE SCHEDULE (70°)

POT LIFE (1.5 GAL VOLUME): 45-60 minutes

TACK FREE (DRY TO TOUCH): 2-4 hours

RECOAT OR TOPCOAT: 2-18 hours

LIGHT FOOT TRAFFIC: 5-7 hours

FULL CURE: 24 hours

 

COVERAGE

Recommended for use as a topcoat on epoxy, concrete, plywood, and Graniflex Broadcast Systems.

COVERAGE PER GALLON: 175-250 sq. ft.

MIX RATIO: N/A

RECOMMENDED FILM THICKNESS: N/A

PACKAGING INFORMATION: 1 gallon

PHYSICAL PROPERITES

FLEXURAL STRENGTH: Pass

COMPRESSIVE STRENGTH: N/A

TENSILE STRENGTH: 4500 psi

ADHESION: Concrete Failure

VISCOSITY: 600 cps

ABRASION RESISTANCE: N/A

ULTIMATE ELONGATION: 40%

HARDNESS: 70 Shore D

VOLATILE ORGANIC CONTENT: 0 g/<4.5r grams/lite

SHELF LIFE: 1 year in unopened containers

CHEMICAL RESISTANCE

REAGENT: RATING

URINE: D

XYLENE: D

MEK: C

ISOPROPYL ALCOHOL: D

METHANOL: D

GASOLINE: D

SKYDROL: D

BRAKE FLUID: D

NITRIC ACID 10%: A

HYDROCHLORIC ACID 20%: D

LIMITATIONS

  • Floor will be very slippery until dry
  • Temperature, humidity, and ventilation could affect dry time
  • Not intended for use on rubber, cork, wood, or bamboo flooring

BENEFITS

  • Must perform a moisture-vapor transmission prior to application
  • Clear coating may turn opaque and cloudy due to moisture penetration, especially exterior
  • Surfaces may be slippery when wet
  • Do not apply when substrate temperature is below 50 degrees or above 85 degrees
  • Apply in thin coats
  • Do not thin the product

INSTRUCTIONS

  1. In equal parts, combine 1 Part A to 1 Part B
  2. Using a stir stick, stirring constantly for 1-3 minutes
  3. Apply to surface using a 3/8” nap roller or a magic trowel

NOTICE TO BUYER:

DISCLAIMER OF WARRANTIES AND LIMITATIONS ON OUR LIABILITY:

The Concrete Protector (Division of Incredible Products, LLC), warrants that all products are assembled under rigorous quality assurance specifications and that all information supplied is exact. All information supplied is not to be taken as a warranty, but for you to conduct your own test to determine if the given product is suitable for your distinct purpose. The following list of properties should not be interpreted as specifications. CONVEYED OR SUGGESTED, NO WARRANTY IS BUILT UPON ANY DISCOVERED RESULTS OR INFORMATION YOU WILL OBTAIN DURING USE. CONVEYED OR SUGGESTED NO WARRANTY IS BUILT THAT THE GIVEN PRODUCT SHALL BE MARKETABLE OR THAT THE GIVEN PRODUCT WILL BE FIT FOR ANY DISTINCT PURPOSE. NO WARRANT IS BUILT UPON SAID INFORMATION OR THAT THE GIVEN PRODUCT WILL NOT INFRINGE UPON ANY PATENT. The Concrete Protector is NOT liable for, direct or indirect, inadvertent or onsequential damages. The Concrete Protector’s liability is and will only be limited to the net selling price of our products or, at our discretion, the replacement of our products. Upon delivery of our products, your acceptance means that you accept all terms of this warranty even if other documents and or purchase orders astray from the terms of this warranty. No representative, on our behalf, is permitted to make any representation, warranty, or assume liability with any sale of our products. OUR PRODUCTS CONTAIN CHEMICALS THAT CAN CAUSE SERIOUS PHYSICAL INJURY. BEFORE THE USE OF OUR PRODUCTS, READ ALL MATERIAL AND FOLLOW ALL LISTED PRECAUTIONS TO AVOID ANY BODILY HARM